TPL03 Setting out platework and rolled steel section from drawings
Issued by
Connected Competence
The candidate has demonstrated the knowledge, skills and ability to safely and accurately set out platework and rolled steel section from drawings using appropriate materials, equipment, tools and techniques. This includes reading and extracting information from engineering drawings and specifications to correctly mark out plate and rolled steel section steelwork and draw set outs for configurations on to template/floor.
- Type Validation
- Level Foundational
Skills
- Assuring Continuing Competence
- Correct Tool Useage
- Draw Set Outs
- Methods For Set Outs
- Platework And Rolled Steel Section From Drawings
- Practical Skills
- Rolled Steel Section
- Working Safely
Earning Criteria
-
The candidate has successfully completed and demonstrated the following:
-
Importance of health and safety in the workplace and understands relevant aspects of current health and safety legislation and always demonstrated this understanding
-
Observes any specific safety requirements relating to the preparation and correct use of the materials, tools, equipment and methods of working
-
Prepare work areas, materials, equipment and tools
-
Apply appropriate mark out methods for set outs including centre lines, column work outlines, component and fittings outlines, flange outlines and hole centres
-
Draw set outs for plate work configurations and rolled steel section steelwork fabrications
-
Check that the set out for the column bracing and end plates has been completed correctly. Reinstate the work area
Standards
National Occupational Standards (NOS) are statements of the standards of performance individuals must achieve when carrying out functions in the workplace with specifications of the underpinning knowledge and understanding. NOS are developed by Standard Setting Organisations who consult with employers and stakeholders across each of the UK nations.